Current page: 31

• Check whether the total number of tracks on the newly recorded MiniDisc matches the total number of tracks on the master MiniDisc. If they do not match each other, combine or divide tracks using the edit operation. (Pages 27-28)
• This function can not be performed from pre-recorded (playback only) MiniDiscs.
2. When the recording is complete, remove the newly recorded MiniDisc and load the master MiniDisc into the MD-MS702.
   • Do not mistake the master MiniDisc for the newly recorded MiniDisc.
3. While in the stop mode, press the EDIT/A.MARK/TIME MARK button to select "NAME STAMP".
   
4. Press the ENTER/F.PLAY/SYNCHRO button.
   
   • To cancel the operation, press the /:OFF button.
5. Press the ENTER/F.PLAY/SYNCHRO button.
   
   • The character information of the master MiniDisc is being read.
6. When the unit displays "CHANGE MD", remove the master MiniDisc.
   
   • Remove the master MiniDisc without turning off the power. If you do, the operation will be canceled.
7. Load the newly recorded MiniDisc into the MD-MS702.
   • To cancel the operation, press the /:OFF button.
     
8. Press the ENTER/F.PLAY/SYNCHRO button.
   • The unit will finish recording the character information and enter the stop mode.
     

Note:

• If the total number of tracks on the master MiniDisc does not match the total number of tracks on the newly recorded MiniDisc, the unit will display "Can't WRITE" and the power will be turned off.
  If this happens, adjust the total number of tracks on the newly recorded MiniDisc using the edit operation, and then try again from step 2.

Current page: 31